Hi to all B & O enthusiasts,

When I attempt to start the Beovision 9000 it shows the message SW.1.10 error 1 on the lower display panel. Does anyone know what this means? Trip to the technician, expensive repair or graveyard maybe? If it is the graveyard, I would gladly donate to anyone who could use the parts. I would really like to keep it going though as it is a beautiful design.

Thanks in advance for any help.

anodyne1.

anodyne1:

Hi to all B & O enthusiasts,

When I attempt to start the Beovision 9000 it shows the message SW.1.10 error 1 on the lower display panel. Does anyone know what this means? Trip to the technician, expensive repair or graveyard maybe? If it is the graveyard, I would gladly donate to anyone who could use the parts. I would really like to keep it going though as it is a beautiful design.

Thanks in advance for any help.

anodyne1.

It sure is a beautiful design so I hope you are able to fix it and wish you all the best. I can't offer any advice as I have no experience along those lines but I do hope some of the more technically minded forum users are able to assist you. Perhaps Keith can offer you a solution? Good luck and I hope it doesn't meet its fate too soon!

Simon. 

Many thanks for the good wishes!!

Where are you based? It can sometimes help should we need to recommend a helping person! Would hate to see a 9000 binned! Always fancy a 9002 some day!

I am in Geneva, Switzerland.

You get this error when there is no communication between TV and ControlCenter ( stand ). 

If the TV doesn't power up the problem is there.( Red led on top of TV should be on in st-by )

If TV powers up the problem can bee blocked MasterLink. Try a good ML-cable between TV and ControlCenter to check communication between them. If this helps then the problem is somewhere else in the ML.

 Graveyard is not an option for any B&O.  :)

Moritz