Has anyone installed the STB bracket on the back of a 720p Beovision 9?

If so can you send me a picture, I'm just curious how it all goes together. . .
thanks

MJM 

The BV9 comes with four holes pre-drilled for the STB cover/bracket, but the first few models didn't have them pre-drilled - which isn't a major challenge. I have one installed, and it is very convenient to access (snap off cover) and, as it is placed directly above the BS3, cable management it very easy.

Roger

This information is freely available on the STB website, wasn't that a good place to start?

the stb website showed the new bracket. . .i have the older one;

thanks roger. . . .would you mind sending me a picture of your install?

I'm reluctant to drill holes in the bv9. .

thanks

Just checked with B&O - only the first 300 BV9's didn't have them. I do understand that you are reluctant to drill the holes, I took a couple of pictures but they didn't tell anything but the fact that I need remove some dust from the back of the telly 

You can ask your dealer for a quick guide: A "Drilling and mounting instruction" (3543481), which will guide you through the drilling of new holes and how to mount the STB Cover on the back of BeoVision 9-50. It comes with four screws (4 x 2013081), for safe mounting of the STB Cover. They have supplied these free of charge to owners of the first 300 sets.

Roger