Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
Page 1 of 1 (8 items)
-
Well I've checked the other driver and it seems fine so I've sent you a PM Martin!
-
Thank you Martin - tonight I'll take the other driver out and see what its condiction is. If it's in a similar state to this one then I might give up on them. If its ok, however, I might take you up on your offer of locating a replacement. Many thanks David
-
Fresh from the successful refoaming of my CX50s I decided to try and resurrect a pair of 2702s that came along with a BeoGram 1200 I bought. After removing the first fret it was clear to see that the surround had long since perrished so I removed the driver and began to clean it up. It was only then that i noticed the tilt of the cone and how much it
-
Thankyou for your replies - it certainly sounds like it may be beyond my novice skills to repair at the moment ! I love the design of it though so it will just have to stay where it is and look pretty for the time being!
-
Hello all, I've recently taken the plunge into the vintage B&O world with a slightly unloved Beomaster 1200 off eBay – she's missing her tuning slider but has all her other sliders and still powers up and bring life to my Beogram 1000 and RL1000s. I'd like to get her in tip-top condition but the big problem is that there is a definite
-
I've not used my MX4000 for a while (18 months or so) and have begun using it again in my kitchen, however, it keeps turning off after differing intervals. Sometimes it will go for 30 minutes before switching off and sometimes only a few minutes - can anyone offer any help? FYI - I've had it from new (1993) and it had a replacement chip/board
-
Hello, I've just retired my trusty MX4000 after 13 years of service and have bought myself a new LCD tv (non B&O) as a replacement. I had my BeoLab 6000s connected to the MX4000 via powerlink and everything was dandy, however, the new TV only has a digital/coax optical out! I have a 5.1 amp that I can route the optical signal into although it
-
Hello all, I have a question relating to my 6000s and connecting them to non-B&O equipment. Currently I have them connected to my MX4000 via powerlink and everything is fine. However, I am looking to buy a new non-B&O LCD TV and am unsure of how to connect the 6000s. Many years ago I bought some B&O phono line signal reducers so I could
Page 1 of 1 (8 items)