[quote user="AdamAnt316"] Yet another question for the group: should I be concerned about the gunk on the arm carriage's transport screw? I'm not sure if it's affecting the movement of the carriage, but I do occasionally notice issues with mistracking near the beginning of LPs. If it's an issue, what should I use to clean it

Hi, Finally, I think I may have learned the reason behind the 'off-center' sensor arm in my 8000: the stylus set-down point on records smaller than 12" is a bit too far to the right, causing the needle to nearly fall off of the record! Is there a way to adjust the distance from when the sensor hits the edge of a record to where the stylus

I track my MMC20EN at 1g and it's just glued to the groove.

Hello! I did the same "mistake" on my 6006: I missed the slider (I found it later inside the chassis) and I moved the counterweight to the front. But then I put back the slider in place and in fact it changed the balancing of the arm (0,75 g) so I had to balance it again and guess what, it was in the correct position before of course! To balance

Hi, I quote Dillen: You will have to dismount the hinge. Press out the steel rod that runs the length of the Beogram, press it leftwards just enough to free the hinge piece and lift off the alu lid. Clean off the remains of the old grease. Sometimes contact cleaner is good, but that depends on the type of cleaner. Then you can add a little kilopoise

I would like to thank you again for your support, Martin, however boring my PMs were! In my turn, I would be pleased to help other members possessing a defective 6006/8000. Cheers!

Hello, Should it be of any interest for some of you fellow Beogram owners, here's my story. I got a cheap (60€) but beautifully preserved Beogram 6006 (similar to Beogram 8000) from a nice man who warned me that although he had all the capacitors changed, the deck remained non-functional. Fine. Being a man of challenges, and a 25-year experienced

Hello, On my Beogram the aluminium finish appeared ruined after some soap cleaning. It wasn't: apply a thin layer of flaxseed oil, then wipe out, be happy!

Hello to everyone here, The title says it all : has anyone got one spare for sale please? The problem is my lid won't hold open! Thanks in advance ! Jacques

Hi Peter, Thanks for this nice photo. More photos, please! Especially, I'd like to see the details of your arm assembly to compare to mine.