Hi 355f, read this article from HDTV-magazine: It says that a HDMI 1.1-receiver is all good to handle Multichannel PCM even for the decoded new HD-sounds. www.hdtvmagazine.com Multi-channel Audio for HD By Rodolfo La Maestra on April 21, 2006 This is an excerpt from the HDTV Technology Review 2006 Report by Rodolfo La Maestra. We had not planned on

Hi 355f, How did you make your tests that have give you an other conclusion than B&O:s? /Martin

Hi guys, I have followed your discussion about IF BV7-40 Mark III (BS3) will support multichannel PCM at 96khz/24bit at all channels! This is the main question IF it will fully support decoded Dolby TrueHD and DTS-HD sound from a Bluray player. Earlier this automn I asked Struer this questions and got the following answers thru e-mail: Read the mail

Hi, I sent a question to B&O in Struer IF Beovision 7-40 Mark III could be upgraded with the new sound-technology. The answer is YES. We can upgrade our Beosystem 3/BV9 or BV7-40 markIII with this new technology.

B&O wrote this when I asked about the technology: There are basically two main advantages of Adaptive Sound Technology. The first is to give the customer the freedom to place loudspeakers and listening positions arbitrarily, as most people already do, without a severe loss of spatial qualities in the recording. The second is to give the customer

Thank you Quim!

Hi, I think this two modules are digital surround-modules. Can anyone check their software-list in "custumer-menu" if this 4.12a is the latest for these modules. /Martin

Hi, I have recently the new sw 5.0 installed in my BV7-40 markIII. In the two sound-module software DSM DSP and DSM FEP , I have 4.12a. Is this the highest software for these two modules in Sw 5.0? Regards Martin

Hi, Gerd! Will it include Beovision 7-40 mark III? Will it be possible to upgrade 7-40 markIII with the new DSM-module? /Martin

Hi Roger, I have just upgraded my BV7-40 to sw 5.0. Just to make sure that all pieces in the SW 5.0 Built 341 was upgraded, can you tell me if all my sw-modules are updated as it should be in software 5.0? I have now the following: H8 5.00 H8 Bootloader 1.10a IOP SW 23.00a M2 SW 5.00a Stat disp Sw 2.00a M2 STB Table 5,27b PW STB Table 5,27b DSM DSP