Good set of pictures Andy.. I am almost always up by 6am and at my PC by 7am to start work..

To get the Beocom 6000 case open you will either need a tool as shown in the picture or a very thin bladed blunt tool to slip down the side. After you have removed the two screws at the bottom of the battery compartment, carefully slip the tool both sides at the top of the battery compartment only allowing the back to move apart a couple of mm (milli

Given that there are no exposed wires on the cable, then this is unlikely to be your problem. Based on your feedback, I took particular note that you have the AVANT connected to a surge protector, this is both good and bad in my view and you will see why below. It may be that you just had a serial of mains " Brown Outs " as defined in the

Nicolas, Based on your " Problem Statement " it sounds like you have some king of interference or pickup from another source. You appear to be saying that everything has worked without problems until yesterday, if so, then my first question would be:- Has anything changed in the surrounding environment in the room? Have any wires or connections

[quote user="stefan"]But the repeat functions on the GO button and the MENU (EXIT) button never worked...(??)[/quote] Well, I had a look into the PUC database file for the NEC version and it has the repeat function correctly setup for both MENU and GO so I am not sure why its not working for you.

There is actually two Apple remotes in the PUC library, one (the early version made in 2007) uses RAW for some reason which is an image copy and therefore cannot do repeat/continuous. The Apple remote actually uses standard 32 bit NEC protocol which DOES support repeat function. So, if you have the early version of the Apple remote loaded into your

Please do not consider yourself "thick" its actually a very complex subject and one I plan to write an overview on when I get time. Bitstream is not a protocol, it is a bit representation on a timeslice basis for both the PULSE and the SPACE which makes up the PERIOD of one binary bit. The timeslice is the smallest time of any pulse or space

A very warm welcome to Beoworld.. Generally speaking if an AVANT is turning off without any user switching it off leaving only the standby light on means most likely that the safety circuit has been triggered. This is further supported by your statement that you apparently lost the SAT setup information. With regards to your questions:- This is not

When the firmware is updated, the battery always shows as flat. Subsequent to doing the firmware update put the Beo5 on the charger for a time and then go back and do another download. Do NOT remove or unplug the battery.

As stated, you use the same code again To unlock the glass doors press SHIFT 9 0 3 6 9 with no more than 2 seconds. The display shows “ UNLOCKED ”.