What is the damage to the grey plastic part? I bought some of this mirror film for a different project, but I had some off cuts. I decided that I thought it would look good if I covered the grey plastic side on my base unit (this was the side tha was showing into the room when the base was in use) and I thought the grey a bit dull. The plastic was smooth

I can't see that you will have a problem if you add extra wire as you are thinking but there does seem to be a maximum length you can have. I saw this in the Masterlink Manual when talking about BeoLink Active - The cable between IR receiver and BeoLink Active must not exceed 5 metres (supplied). A special 15-metre low-capacity cable can be ordered

Well, I have been playng with my new Light Manager Pro B&O and once I'd worked out how to use the software, I have got it controlling my sidelights via a Beo4. You use the LIGHT button then can assign 1 to 99, Red Green, Blue, Yellow, Up, Down, Left Right, STOP, Keyring Short, Keyring Long and Joystick up, down, left & right. so there are

Thanks for the good wishes Chucky Getting the RF codes for the blinds was more luck than judgement. And as yet they only work on my old remote. I have been experimenting with a Marantz RC9500 touchscreen remote (Philips Pronto RU990 equivalent) for about 5 years. This is an IR learning remote and I have discovered it can also "send" some RF

[quote user="chucky"]I have recharched it for more then 2 days, I am affraid the firmware-update didn't succeed becaused windows killed tthe usb connection while updating.. [/quote] This may seem obvious but did you recharge it on the charger plugged into the mains power socket or on the USB on the computer? on my Beo5 I had to charge

Hi, Some time ago I installed and ran the Product Configuration Guide downloaded from this site. it all worked fine and I used it a few times. I tried to run it today and got the message - BEOCONFIG caused General Protection Fault in Module BEOCONFIG.EXE at 000D:02AA. It will only allow me to click "Close". I have re down loaded and installed

[quote user="chucky"] How big is the box? [/quote] I have measured it and it is 6cm X 6.25cm X 2cm ( 6cm front to back - 6.25cm wide & 2cm deep) the wall plug/transformer is a euro 100v/240v to 5v 200mA output via a standard USB port with a 1m USB to mini USB cable (so if you need to put a longer cable it will be simple) Despite being

[quote user="chucky"] Then you can put it anywhere as long as there is a socket, brilliant. Tx [/quote] It is powered by a wall plug that is USB to Mini USB so if the socket is too far you can put a longer USB cable. It is very small and neat.

[quote user="chucky"] How big is the box? [/quote] About 2/3rds the size of a credit card & as thick as your thumb! I'll measure when i open it and let you know. Stoobie

Hi Chucky I have just bought one of these (B&O Version). It says it works with RF blinds so may work with the Velux RF (which is quite likely to be made by someone like Somfy as thay make most RF blind/window controls). However, the guys at JB Media were extremely helpful and answered my query emails really quickly so you may want to email them