Tom, The Beosound 9000 has more "Test Modes" than almost any other B&O product, it has 74 tests to be exact as follows:- Tuner test modes TM 01: Automatic offset-adjustment for FM TM 02: Manual offset-adjustment for FM TM 03: Status for offset-adjustment TM 04: Variant status TM 06: Check RDS name TM 07: Setting up of tuner variant Master

The Masterlink Gateway does exactly what it says on the box, it converts Beolink sources and commands to a device connected to either the RS232 port or over the Ethernet connection and takes commands from the RS232 or Ethernet port and via macros setup in the Gateway triggers Beolink commands. This product is not made by B&O. The Gateway implements

Based on your description, it seems likely that your Beocom 6000 is faulty..

If you mean by your question you want to change just the wall socket to RJ45 and still use it for Masterlink, then your first problem will be the number of connections. Masterlink requires 9 wires plus ground connection. If you mean you want to use the Masterlink cable for the transmission of Ethernet signals instead of Masterlink, then you are likely

Philippe, Your app looks very good indeed, well done. Lee, forwarded your e-mail to me last night for comment and I was very impressed based on the screen shots. I look forward to reviewing it in detail..

[quote user="beojeff"]As I recall, the earliest version of the Apple Remote PUC on the BeoSystem 1 had issues with the scrolling from holding down buttons. However, the current Apple Remote PUC on the BeoSystem 3 works quite well.[/quote] You are correct.. it is because Apple uses NEC protocol and when you did a repeat function it should just

As a general statement it should always be better to use the PUC to control Set Top Boxes and other units and is essential if you want the box hidden out of sight. Where it is a product that is not directly linked to an audio or video product then direct control is usually the only way to control the product because it will not/should not be in the

If I have understood you problem correctly, then I would say it should work. To be sure I created a configuration as you have described yours and it works for me. So, that leaves me to conclude that either You are not running the current version of the configuration tool version 3.87 You have deleted one or more buttons in the process of creating your

I am very pleased that you managed to recover your configuration...

Your problem sounds like an earthing issue to me. The shield of the Masterlink connector (the metal strip either side on the plug itself) is connected to the 3 screens within the Masterlink cable. If you look at either side of each Masterlink plug you should see lots of marks where it makes connection to the socket ground pins when plugged in, however