Tony, I have outlined the options available in a PM to you.

I have a repair guide, but not a service manual for the US version

You can talk about quality of cables and they are important, but what really counts is impedance matching to the signal and even sharp bends in a cable can effect the impedance seen by the signal and therefore may degrade what you hear or watch. So, don't get me wrong quality cables are important, but routing and how you connect them are key to

Version 7.5 is for the latest BeoVision 7-32 & 40, so to be clear on all the possible variations BeoVision 7-32 Type 9310 to 9320 is 6.31 BeoVision 7-40 Type 935X is 6.31 BeoVision 7-32 & 40 HD Type 933X to 936X is 7.5 The type number of your BeoVision can be found on the back cover.

Bang1, There is very little on the Beolink Wireless 1, but if you have a particular question on it I suggest you start a new thread with that (those) questions.

Tony, If your handset says NO SIGNAL then the radio signal between the base and the handset is lost. I am assuming that you are in range of the base station, so the problem will be the RF chip on the PCB in the phone. This means the pcb would need to be replaced. Are you a technical person who (with instruction) could do basic board replacement ? Are

Tony, You answer means that you have a Mark I phone and I also assume that you have unplugged the base from the power and re-connected it given your following answer. If you have done this and just need to re-register the phones then your handset properly says NOT REGISTERED in the display. When you take your handset off the base press the centre button

Which version of Beocom 6000 do you have ? At the left of the dial is there a black DOT on the key or the words INT ? A Mark I has the black DOT and a Mark II has the letters INT

DoubleR, Your experience is what I was talking about earlier in this thread, if your screen shows signs of problems, the longer you keep using it, the more likely it is to cause failures in the electronics, which in turn will cost you more to fix.

The latest version is 7.5