CLOCK 2… When the BeoLab 3500 is switched to standby, the display will show the time and the red standby light. The time indication remains on when the BeoLab 3500 is playing, but whenever you operate the BeoLab 3500 (either close-up or by remote control), the display will give you a brief status on the operation. This is the factory setup. If

With regards to adding the DVB-T to the AVANT CTV 28, I am sorry to inform you that this cannot be done on your version. It is true that they use the same software except for AVANT DVD mark III, but the chassis is different. Also, I have to agree with Peter, that the cost of the upgrade is difficult to justify particularly for UK users where the functions

The Beo5 has three IR transmitting diodes for controlling B&O and other products. Clearly B&O wish to limit "the other products" to vendors it has approved, meaning they have a business partnership relationship with them, for example Lutron for lights It will control all STB's which are defined in the current STB controller table

Petros, Sorry for the delay in getting back to you. One thing about the Beolink protocol which needs to be understood is the principle of Video & Audio master where you can only have one master of each type and all other audio and video products on the Beolink must be slave products. So you have a Beosystem 3 and an AVANT which are normally both

Your problem is called field collapse and is quite common in older TV's. It occurs when the vertical oscillator or the driver from it to the scanning coils fails. For a good TV technician this would be a fairly straight forward fault to fix.

The following formats will playback on a DVD1 PROVIDED it is not an early version where there can be some issues:- DVD -R DVD +R DVD -RW DVD +RW Having said the above DVD -RW has never been part of the B&O spec and in early versions they would not playback DVD -RW discs

If there is no sound and picture from SAT & DVD then I would be surprised if it is the tube unless there was an internal short which took down the HT supply. The rest of the set would continue to work because it would be using the low voltage sections of the power supply. I think you need to get the dealer out to do some voltage checks, if it is

I agree with almost all that has been said, however I would point out Peter that I believe you will find in the future that the DVB-T will have a software upgrade to support MPEG4, now before you say it, I agree we may have to wait a long time for that software upgrade to arrive as I had to wait to get the software update to allow digital text (BBCi

Beosound 2,3 & 4 can only use SD cards up to 2GB

You may wish to review the AVANT list for Software 3.6 table 3.91 HERE