|
Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012 READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
Sounds like it is in need of service. Have you tried with no other things connected (speakers, link things etc...) ? Hard to diagnose at a distance but check voltages to the processor module and the reset circuitry. Martin
-
Around the antenna holder, each end of the string goes around about 3/4 of a turn, before meeting up at the spring on the pin sticking out of the side of the holder. Mark the strings where the knot goes to make a tight connection without too much string stress. Take off the dial string again, tie the knot on the spring, rotate both the knob and the
-
On to the antenna clamp which also has a groove for the dial string. This view also shows the antennas rotational joint and the leads plastic holder as decribed above. Martin
-
A bit higher up, the string(s) pass a captured nylon bushing. It does not rotate and is not supposed to either. The strings simply slide over - and around - it to convert a vertical pull to a horizontal. Still held by masking tape at the ends. Martin
-
Back to the snapped antenna string. Restringing things like this is not for people with a tough temper. Keywords are patience, masking tape and strong coffee. The reason the string had snapped was soon clear in that the rotating antenna had completely seized at it's rotational support. This was taken apart, cleaned, a little fresh silicone grease
-
The fuse holder practically fell apart in my hands and new clamps were mounted similarly to the two holders on the power supply chassis. Much better. I measured around a bit but couldn't find any obvious reasons for the fuse to blow but we're not done yet so maybe something will come up. Martin
-
First things to fix on the main chassis will be the snapped dial string and that no-good fuse holder. Martin
-
Sidste chance for et komplet anlæg ! Martin
-
Hallo Norbert, Welche Teile brauchst du ? Martin
-
Hvis det er din avatar, du mener så - klik på dit navn i den øverste linie til højre på skærmen. - klik på "edit my profile" her kan du så slå din avatar til eller fra og upload'e en ny. Martin
|
|
|