You have offered a key piece of extra information in your reply, you said "regarding "a few minutes to warm up" -mine acts the same way" Well, that points to a tube heater or supply (normally 6.3 volts) problem and is quite common with tubes, in fact many workshops in days gone by would have a "Tube Re-generator" which

I have answered your question in the Beo5 forum HERE

Member Cone, asked the following question in the general forum, but I will answer it here. He said: Hello, I´m trying to programm BEO5 for Beocenter 9500+Beogram9500+LX5000+Stand+VX7000 on main room. I would apreciate any help. Regards" Whilst the Beo5 can control older products provided they can be controlled with a Beo4, The Beo5 Configuration

When you say "system shutting down" do you mean it goes into "standby" or do you mean it was if there was no power at all.

I will start with your last comment first -- caps issue ? you said, well these sets were produced at a time when the electronics industry was having a lot of problems with Electrolytic Capacitors designed for use in televisions and audio equipment. The two major issues were they either dried out or leaked. However, if everything else with your Beovision

The option information is stored in the device (product) and not in the IR "Hockey Puck" as you call it. The IR Receiver/Transmitter receivers the signal and converts it into TTL levels for the attached product plus drivers for the two LED's As the "Puck" apparently works for all functions other than the IR, then the problem

There is no reason, I can see, why you cannot purchase the kit in Milan. In fact there is 5 B&O outlets in Milan and I have listed below the four which are nearest the city centre , so you are well served. I must, however draw your attention to the comments made by David from Kings Street. You will need to have the necessary tools available to ensure

I have sent you an e-mail with an updated configuration file to test. Whilst I don't have your configuration to test it on, I believe it is working fine.

That's good. To be completely sure, I am going to ask you to provide me with the results of Beo4 button press's listed below and from your answers I will provide you with an updated Beovision 7 template which hopefully will work as it should. So, please give me the results of the following BEO4 button presses with the DVB selected (DTV) RED

For you to understand the nature of the problem you have described, a few points need to be understood:- There are just two types of DVB-T/S which are only found in Beosystem 3 based systems like your Beovision 7 Mark III. The two types are UK or EU (we in the UK like to be different you know) The software version loaded into the DVB-T/S effects the