There shouldn't be any delay assuming its all in the same room. It would be a ML cable from the TV to the 1611 and then a five pin cable from the 1611 to the Audio Aux port on the 9300. Probably better to run the speakers from the TV if it has a Dolby surround module etc. Then just a case of configuring each device to send the sound one way or the

I was hoping that with the fact they where powered off would make no difference to the BV and if both the BS's where set the same then hopefully it would all work. Maybe I should try and set it up and see if it works.

Ok just to clarify, all three are in the same room. Current is BS9000 - ML - BV7 and all works great it plays through the speaker setup of the TV. If I put in a junction ML box in and do BS5500 AUX - 1611 (ML) - junction box - BV7. Only either the BS9000 or the BS5500 will be powered on (not active all the time) if I set the BS5500 (SW 2.3) up to the

Here's hoping number 3...................... A recent 5500 stack has arrived all with European 2 Pin plugs on the end of the power leads. Instead of cutting these off and putting UK plugs on the end I was hoping that someone might have an official B&O (the grey one) 4 socket power gang that perhaps I could use. If I can't get hold of the

Hi all, Is it possible to have two separate music systems connected to a BV7 via ML to play music through the TV's speaker setup? Current there is a BS9000 connected to the BV7 via ML and this works fine. Now if I add a second one, e.g. a BS5500 stack with the Beolink SW etc, can I set that up to work as well? So two parts to the question. 1. Is

Here's hoping number 2...................... I recently managed to get hold of a later black keyed Rosewood (again :-) ) BeoMaster 1000 with a pair of BeoVox 1100 speakers. It's all been cleaned out and a bulb replaced and it looks like mint inside, no stains or smoke etc. But, it doesn't have the FM Stereo module and by the look of it,

Here's hoping number 1...................... I've managed to get a pair of Rosewood M150's, one is all up and fine with a new Peerless Bass unit and I just need to sort the casing out on the other to get a nice pair of speakers. But, they have no frets or stands! Does anyone have any? Cheers GUY

There's a LONG allan key required to get the TV off the stand, the setup isn't really strong enough to move it all together. The TV can be moved flat, face UP with lots of packing underneath to support the sides, etc.

Is this is white? He asks hopefully.............

Neil, its really only good if you aer going to use a DTV device off the back of it using the internal STB. The tuner is only analogue so only 5 (if your lucky) channels, and then only until they turn if off!