9 LEE: joeyboygolf: The premise that I work on is that I'm doing the job on the cheap so I'll take the chance that if everything is at the same potential (but possibly not zero) then there should be no problem. Not sure that we should be advising people to 'have a go' or 'take a chance'... You may indeed have done it hundreds

seanklemis: joeyboygolf: Unless you wear frilly nylon knickers you can earth yourself periodicaly by touching the chassis of the device. im affriad i work with anti-static and the correct way woudl be to touch the chassis if indded it were plugged in and the earth connection to the mains outlet was connected otherwise they static has no where to discharge

There is such a load of **** talked about this upgrade. I have done loads of them and all versions simply required a chip change. Where all these other stories come from is a mystery to me! Yes you can use the Mk3 service manual for help in getting it apart. Basically you will need to :- Remove the glass door Disengage the carriage Remove the rear(grey

Not with you Dave. The beogram 3000 does not have RIAA neither does the Beosound 4! Are you talking about a link between BM3000 and BS4?

You will need to provide a RIAA pre amp if you plan to use it with the Beosound 4

Is the stylus/cartridge any good? Remember that they cost £120 minimum by the time all the costs are added in. If yes then the Beogram is worth £170 on it's own!!!

Weebyx: varunseth: Hi, I have beolab 8000 & beolab 6000 and want to attach them to non b&o preamp. Is there any special aspect I need to check in the preamplifier ? Is anyone else using a preamp successfully with these speakers? Would appreciate suggestions. Thanks You need to supply the speakers with 5-12V to make them power up. it is the yellow

B&O always said that these Beocenters should be flat on a shelf or similar. Wall mounting is not possible as the cd mech is not fixed in place inside the unit. Medogsfat did wall mount one a few years back at approx 35 degrees with success. Worth sending him a PM

Sounds like a masterlink or MCLconnection problem. Can you try other cables? I assume that the 9500 performs as it should with the speakers connected direct? When you say a control box do you mean a type 1611 converter?

Anyone?????? I have not had a BC1 for 2 or 3 years and I can't remember.