For SD (Standard Definition) RF transmissions from the master "Link" output of a Beovision to the link rooms I suggest you use double screened CT100 or FT100 coax cable as below Example of pricing for this cable is HERE

If you have or are going to purchase an LC2 which is not one of the last to be produced by B&O (i.e. does not have the modification), then you can purchase the PCB and replace it in the LC2. You can only buy this module from B&O and whilst there may be no B&O dealer in your town, it is small enough to be sent by post if needed. However,

Unfortunately, Beoworld does not currently have a Service Manual for this model, however you can obtain one from HERE

You said:- About LC1-2, some people told me these don't work in the same room with a plasma tv... what can you tell about? They told me plasma monitor causes interferences. Is it true? It is true, however later versions of the LC2 had a new board which solved/reduced the problem. The IR of the LC2 would not work due to light and electrical noise

In order to deactivate the PIN code system you must first key in your previously chosen four-digit code, and then key in the ‘0000-code’, which disables the function. While BeoLab 5 is in standby… Press ss, ss, and STOP in quick succession on the Beo4 remote control. The indicator light shines intermittently red (1 sec.) and green

Mike, Normally resistors are marked like 39R when they have a wattage over one, below they use the normal coded bands. With regards to the capactors, the original parts list actually shows them as 25 volt

Eric, As you have a Beoport box you ONLY install Beoport 4.81 software, nothing else... The reason you were going into the install each time you started previously is because one installation was overwriting the other.

Mike, There is in fact 4 inductors in total:- L1 is 6.8mH (Milli Henry) L2 is 1 mH L3 is 0.33 mH L4 is 0.33 MH If you upgrade your membership to Silver or Gold you will find the Service Manual for all the variations of these speakers.

Mor, I am not clear what you are connecting to what. In your title you talk about "Datalink" which does use 7 wires, but then you talk about the "Masterlink handbook" and subsequently talk about only using one ground. So, could you please state which Beovision you are trying to connect to which Beocentre

Its good that you are up to date, but in your response you said:- " including Beoport and Beoplayer 8.1 " Your sentence implies that you are trying to install both Beoport AND Beoplayer as two seperate installations, please confirm if that is what you are doing ? The Beoport Installation contains Beoplayer and is installed as part of the Beoport