Hi Keith . I'm inclined to think it's not the set . I live in a cottage in the country with a shared overhead supply next door . The problem started after a week ( had the set about 6 weeks ) and after a installing previous versions of software backwards from 4.12 twice to see if that cured it , it started again after a week each time . Got

After about a week it started to turn itself off , there is a ML to a Bv6 and a BS7000 with MCL to ML converter ( no timers set ) , this problem is there even if the ML equipment is on or off , also if the 7 is off and the 6 on say Sat the 6 would loose its feed and couldn't get it back unless you put the 7 on to Sat then press sat on the 6 to get

Anyone know of a power recording device that can be put in the feed so I can tell if the electricity is briefly dipping or dropping out to my 7-40 . I'm having a replacement set a week on Thursday because of a turning itself off problem , had it for about 6 weeks and now it won't switch on again without a power down reset . They only have so

Sorry , I'm an engineer and work in mm , an alternative measurement is 1490000 microns or 3712/64 ths or if you have a horse 14 and 1/2 hands. It you need to calculate the internal pressure the formula is < 1 " of Mercury at 62 degrees F. = 1.132 foot of water = 13.56 inches of water = 0.491 pound per square inch > . Surveyor's measure

Measured mine and are 1490 mm or 58" high ( labs are 64.5" ). Richard

I changed the front right speaker ( BL6000 ) for a Penta , the red stand-by went green but no sound , went into the sound menu and changed the speaker type ( every speaker B&o make is there including Penta and the new Lab10 ) but whatever I chose no sound . By selecting the vacant slot above to penta the sound appeared . Would the service manual

Tried Video and Audio , my dealer said that the Bl3500 is connected with ML so there is a difference but will look into it further , suggested that I have the TV on and power to the Penta's then connect the powerlink and see if that boots them up . Richard

I knew it , the wife went to the shop and wasn't as long as expected , I had a Penta in the middle of the door and low and behold she walked into it " What's that doing here " . Before she could get to the rolling pin I explained I was experimenting . Anyway , no display , I have a Bs7000 MLed to the 7-40 ( all speakers connected to

I have got both and could try , will have to wait till the wife is out of the way , I can see her face now if I appear with a Penta under my arm in her day room ( I promise it won't be stopping here my dear !!! ) , I thought someone might know and save me a difficult explanation . Richard

Will the Penta speakers displays work when connected to a Bv7-40 or a BeoSystem 3 , I want to use Penta's in a cinema set-up and wondered if they had now dropped this function ? Richard