The MX monitors all power supplies. If the voltage of one path is not high enough or to high, it will switch off. Try the self test and the last error code, it will tell you if it was a power fail. "Menu 0 0 play" A cold cap will work better than a hot cap. So the time will become shorter and shorter. There is no real hot spot in a cap, it's

Hi, TR20 = IRF624 http://www.datasheetcatalog.org/datasheets/1150/283803_DS.pdf Alternative IRF634, around 1 Euro... double capacity, but available ;) http://such001.reichelt.de/?SID=2276Exn9S4ARYAABcVfuYfe44b740b252b2aec7397f434ac11052;ACTION=444 Check all blue caps and their solder pads. Martin

The AV9000 uses the same mainboard like the MX6000/MX7000. And the problems are quite the same... some capacitors and broken solders around the blue plastic caps. http://forum.beoworld.org/forums/p/24571/191760.aspx#191760

... or you install this little board in your preamp of the BM6500/7000. Cut 2 wires and it will work. I dont know, wether this RIAA board is still available. B&O part number: ???

100% agreement :)

I think there is a option in the setup menu of the LX: Powerlink On/Off?

And clean the surface with a paint thinner. The defect cap has lost acid, it can corrode the copper and it can make a shortcut. Grab and rotate works perfect, i do it the same way, never a defect copper layer. Clean the solder with a unsolder copper wire, sorry, dont know the english word for this item... There is no need to use smd again, quite normal

These smd caps on the picture are definitly gone, defect. It's visible, that the top of the cap is already round and deformed, not flat any more. At least the two bigger ones have got pressure inside. Replace them with quite normal caps and it will work again. 90% will do it... :)

Die allermeisten BL1000 haben ein Problem mit dem Batteriekasten und dem Kabel... das Kabel bricht gerne am Lötpunkt ab. Wenn salzhaltige Flüssigkeiten eindringen, geht die BL1000 nicht mehr in den Standby und bleibt permanent eingeschaltet, sie frisst dann Batterien. Ein anderer Effekt ist, sie simuliert auf tot und macht nichts mehr. Sie

... and some more things: broken solders on the cpu board connectors. Resolder them. If the BM was used in a link system: Replace also the 80C32 cpu chip. DO NOT USE: ATMEL or compatible 80C32x2 and NXP cpu's, they cause exactly this ir receiver symptom. I can only recommend Philips and Intel cpu's. These are verified.