Jeg tilbyder hjælp med udskiftning af kant-ophæng på de fleste B&O modeller men jeg sælger ikke delene dertil. Jeg har engang solgt lidt men jeg gør det ikke mere. Årsagen er den simple, at mange folk siger, at det er ååh så let at udskifte skumkanter selv og mange ejere får alligevel

Nej, det er som regel et forholdsvist lille indgreb. Der er komponenter for omkring DKK 100-200 afhængig af kvalitet og antallet, der skal skiftes og et godt værksted kan lave det på en time. Problemet er bare, at mange værksteder ikke kan diagnosticere sådan en fejl og vil forsøge at udskifte hele modulet. Det lagerføres

Man hører langt flere detaljer i hoverdtelefoner end fra højttalerne. Der sidder en stribe afkoblinger (kondensatorer) i forbindelse med strømforsyningen til processoren, som også styrer volume/tonekontrol. Det er sikkert dem, der er begyndt at svigte. Det er meget normalt og jeg har skiftet dem på de seneste mange apparater

The rivet vias connect copper traces from one side of a board to the other. They are filled with solder so looks just like a huge solder blob until you clear it out. The solder, rivet and board traces work differently with temperature so the connection eventually cracks and becomes intermittent or completely open. You can heat up the solder again but

I always liked the CD50 too. Note that the Beomaster 5000 only mutes locally. That means that only one speaker pair is muted if you press mute on the Beomaster (or local remote control). The other pair can be Beo-linked to other rooms and will mute locally in those rooms. Martin

Hi Norbert The lamps are soldered to either two small pins each or to the little PCB board itself. The new lamps will need to be soldered the same way again. The lamps are a bit odd but not extremely expensive. You have a PM ! Martin

Yes, and I also have the Beocenter 2600 slider that you asked for in the other thread. Martin

Caps, output stage trimmers and cracked solder joints first. If it still has issues, they will be much easier to diagnose by then. Martin

Welcome to Beoworld ! Pull off the volume knob. Using a suitable tool, screwdriver or similar, press in the little tab on the left side of the dial cover (Blue arrow), while pushing the dial cover forward (Red arrow). Take off the clear dial by releasing the two small claws at its front edge. The lamps are soldered in. They are odd specs but I have

Honestly, I would leave the motor alone until the caps and vias has been done. Martin