Need urgently, Stand by transformer 1T1, for BL 4000, or PCB 1 for the same.

Use preamp center on Onkyo and line RCA on BL, shift BL R/L/Line to line, I have my BL 8000s front connected this way and no probs. The center speaker has to be activated in the amp speaker config or with the microphone (Audyssay setup)

[quote user="stotty1111"] In a ml mcl converter used as a passive amp i used a similar sized transformer ie as the original with a 12volt 9VA secondary, giving this has worked fine for the last 18 months! I think the control circircuitry is fairly standard so should work in this app tony [/quote] Secondary coil in BL 4000 is 24 V, I've

If in US here last item on page Image here

Anybody knows how many mA for the 1T1 trafo ??

Stand By Trafo, 1T1,

[quote user="Step1"] I think this is one of the spoiling factors regards the looks of these decks - I appreciate there wasn't really much of an alternative to maintain the tight dimensions (I actually think they could have just about done it by moving the bearing forward though, but I bet either looks or cost was the major factor). They

[quote user="Llewelyn"] If it helps I have a fault BL4000 complete PCB which I can send to you for test purposes? (Or to butcher?) [/quote] Llewelyn Thats a great offer, I will try to get something in the US or nearer by, but if its not posible I will come back to you, could you check if the STB trafo is ok ?? I just love this forum. And Jaff

[quote user="tournedos"] That was entertaining, Jaff! Søren, do you mean the primary winding is bad (shorted, or...)? That should be enough to blow the fuse without any other problems present. If the speaker had a bad short somewere else on the low voltage side, I believe it would've burned the rectifier or something. If you want

[quote user="burantek"] [quote user="Søren Mexico"]even a joke is apriciated[/quote] Why did the BL4000 keep blowing fuses? It was stuck in a Trafo jam. [/quote] I would like some help too