Looking at the pinout of a PowerLink connector, I would assume that the right channel input is not located at Pin 4, which would be the standard location, because Pin 4 is used for the Speaker-ON-Signal at the PowerLink connector. B&O seems to have "misused" some pins on the PowerLink/PC-connector. May be the right channel must be connected

Hallo kutzibach, Lösung 2 sollte eigentlich funktionieren. Da die beiden Telefone jetzt einfach parallel geschaltet sind, sollte das auch in Zukunft hinhauen. Du brauchst also einen Y-Adapter (von Dir als Splitter bezeichnet) und musst irgendwie wieder rückwärts in die Wandleitung einspeisen. Dabei solltest Du jedoch darauf achten, die

I suffer from the same problem with my BeoLink Passive. I found out that PHONO is working fine however. PHONO and A.AUX are both "linked" to the AUX input of my Ouverture so it makes no difference which command is used.

As far as I know the IR eye hockey puck is available with different connectors/cables - but I am not sure. I do not beleive that the older IR receiver (MCL) will work but may be other forum members have more details here!

beoperson: Can I use passive center speakers with Beosystem 1 connected to via ML/MCL converter? Is there any limitations? This is temporary solution. Once I purchase Lab for center channel I will use ML/MCL for linked outdoor BeoVox speakers. ML/MCL converter - it has 5 pin input for older IR receivers. Can it be used with latest IR eye? My assumption

I would try the Beolab 3 speakers using their line input. In this case you won´t need a trigger signal to make the speakers work and you will only need a simple 3.5mm stereo jack to cinch adapter!

Yes, exactly. However you should be aware that two separately shielded leads are required for left and right audio to avoid crosstalk between the channels. Thus 3-conductors + shield is not exactly what you will need! The exakt dimension of the wires doesn´t matter so much IMO. You should use a cable that is suited to be used with LF signals

Hi Michael Max, your configuration should work IMO. You should check your cables for a short circuit. Which impedance do your speakers have? As far as I understood the MCL2P keeps running without speakers connected. Can you confirm this? May be the MCL2P detects overload and automatically power down to protect himself. That would also explain why you

Hallo, passende Stecker gibt es z.B. bei Conrad, wobei Du darauf achten musst, den Typ 080 zu kaufen. Für den 8-pol. DIN-Stecker ist auch eine andere Pin-Anordnung möglich, die allerdings eher selten angeboten wird.

For the BL8000 you will need two coaxial leads for left and right audio and an unshielded wire for the "Speaker On" signal. I fear that Ethernet cables (i.e. twisted pair / AWG xx) are not suited to replace B&O powerlink cables. Fully wired PowerLink cables also provide a shielded lead for data transmission. As far as I know not really